Imprecise calculating adds to Japan’s nuke worries
The course to correcting the broken reactors should be clear by now. There must be systematic cooling and containment, removing fuel to safer conditions, a piece at a time. The volatile fuel both active and spent needs protective covering and burying. The engineering process for accomplishing this should already be modeled. There should be no unknowns.
As for reading, measuring, and calculating radiation leaks at the site, there is no room for error and no excuses. Apologies don’t cut it. Are there no third party IAEA inspectors checking the status?
Get brave and save the world.
Radiation levels at Japan nuclear plant reach new highs
By Chico Harlan and Brian Vastag, Sunday, March 27, 9:49 AM
TOKYO — Already-grave conditions at the Fukushima Daiichi nuclear plant worsened Sunday with the highest radiation readings yet, compounding both the risks and challenges for workers trying to repair the facility’s cooling system.
Leaked water sampled from one unit Sunday was 100,000 times more radioactive than normal background levels — though the Tokyo Electric Power Co., which operates the plant, first calculated an even higher, erroneous, figure that it didn’t correct for several hours.
Tepco apologized Sunday night when it realized the mistake; it had initially reported radiation levels in the leaked water from the unit 2 reactor as being 10 million times higher than normal, which prompted an evacuation of the building.
After the levels were correctly measured, airborne radioactivity in the unit 2 turbine building still remained so high that a worker there would reach his yearly occupational exposure limit in 15 minutes.
The latest confusion in the operation to stave off a full-scale nuclear meltdown at the crippled facility underscores the immense challenges for the several hundred workers in a desperate battle to restart the critical cooling systems. Seventeen workers have been exposed to high levels of radiation, including three who were hospitalized last week, as technicians conducted highly nuanced electrical work in dark conditions that one nuclear industry expert termed “hellish.”
Japanese authorities say efforts to control Fukushima’s overheated reactors will take months and during that time radiation will continue to leak into the environment, extending a nuclear emergency that already ranks as the most serious in a quarter-century. Several hundred workers now shoulder the responsibility for limiting the crisis, amid potentially lethal radiation levels, and Saturday the chief of Japan’s nuclear agency called on Tepco to improve its worker safety.
Evidence of rising contamination in and around the plant has tempered optimism from one week ago, when engineers began work to restore power to the first of the damaged reactor buildings. Japan’s Nuclear and Industrial Safety Agency (NISA) said Sunday that a new measurement of seawater taken some 1,000 feet from the facility showed an iodine level 1850.5 times the legal limit, higher than a reading taken the previous day.
The dangers in unit 2 merely add to the growing challenges. Radioactive water is pooling in four of Fukushima’s six turbine rooms and engineers have no quick way to clean it up, though they have begun efforts to do so in unit 1.
While a Tepco spokesperson said Sunday he did not know how the radioactive water was leaking from the reactor cores, Yukio Edano, chief cabinet secretary, said in a televised interview on Sunday morning that the reactor itself had not been breached.
He said it was clear that water that could have been inside the unit 3 reactor had leaked, but said the reactor itself had not been breached. But he did say that “Unfortunately, it seems there is no question that water, which could have been inside the reactor, is leaking.
Unlike in newer reactor designs, the older boiling water reactors at Daiichi are pierced by dozens of holes in the bottom of their reactor vessels. Each hole allows one control rod — made of a neutron-absorbing material that quickly stops nuclear fission inside the reactor — to slide into the reactor from below, as happened when the earthquake shook the plant March 11. During normal operations, a graphite stopper covers each hole, sealing in highly radioactive primary cooling water, said Arnie Gundersen, a consultant at Fairewinds Associates with 40 years of experience overseeing boiling water reactors.
But at temperatures above 350 degrees Fahrenheit, the graphite stoppers begin to melt.
“Since it is likely that rubble from the broken fuel rods . . . is collecting at the bottom of the reactor, the seals are being damaged by high temperature or high radiation,” Gundersen said. As the graphite seals fail, water in the reactor will leak into a network of pipes in the containment buildings surrounding each reactor — the very buildings that have been heavily damaged by explosions. Gundersen said that this piping is probably compromised, leaving highly radioactive water to seep from the reactor vessels into broken pipes — and from there into the turbine buildings and beyond.
To stabilize the facility, workers are trying to repair the elaborate cooling system, necessary to keep the reactor cores and spent fuel pools from overheating. But for the moment, they are conducting this work in dark, steamy conditions. They must wear respirators, face masks and bulky suits. Nuclear safety experts say they must shift out of the most dangerous areas every 30 minutes to an hour, to prevent radiation overexposure.
Meantime, they’re racing to repair motor pumps the size of automobiles. Their environment resembles a cavern of cables. Some of the equipment was damaged during the March 11 earthquake and tsunami. Other equipment has been corroded by saltwater, which was poured into the facility during earlier efforts to cool the reactors.
“To a layman, you’d be scared to death,” said Lake Barrett, a nuclear engineer who directed the cleanup of Three Mile Island. “You’re working with saltwater around your feet. This is not the way electricians usually work.”
The number of workers at the Fukushima plant fluctuates from day to day, ranging between 500 and 1,000. But Tepco employees account for only a part of the labor force. Last Tuesday, for instance, there were 700 people at the plant, a nuclear agency official said. The figure included 500 Tepco employees, 100 subcontracted workers and 100 members of Japan’s Self Defense Forces or the Tokyo Fire Department.
One subcontracted worker who laid cables for new electrical lines March 19 described chaotic conditions and lax supervision that made him nervous. Masataka Hishida said neither he nor the workers around him were given a dosimeter, a device used to measure one’s exposure to radiation. He was surprised that workers were not given special shoes; rather, they were told to put plastic bags over their street shoes. When he was trying on the gas mask for the first time, he said the supervisor told him and other subcontractors, “Listen carefully, I’m only going to say this one time” while explaining how to use it.
When Hishida finished his work shift, an official scanned his whole body for radiation. He came up clean, except for the very tip of his beard. He was sent into a shower where he lathered up and scrubbed his beard. He was tested again and passed.
A few days later, still worried about the extent of his radiation exposure, he trimmed his beard.